Measurements / Or shop in Lubbock Texas

[BozoWise]

I am on the road and pondering my upcoming situation.....

Anyone out there have some height measurements on their k5's?

I am trying to clear a standard 80" garage door because I can't leave the K5 outside my new home. Damn neighborhood regulations and it not being street legal.

Currently it has a 3" body and stock 52" front swap and stock 56" rear swap with a DIY flip. I wonder if I remove the rubber and remove the body lift could I clear the door driving in on just the rims???

Or better yet does someone have some room in Lubbock TX to store my bucket???

 

[SCOOBYDANNN]

I dont have measurements---BUT---my truck on 38's, 56's in front and 57's w/ 4" shackle flip and 1" body lift fit in my garage

AND

my friends on a 6" lift front and rear on 38's BARLEY fits in his with the tires aired down.

these are both in a typical garage, mine is actually a little shorter.

 

[BozoWise]

Well I am just working off my head but it sure seems much taller then a garage door right now. I'll have to wait until the 23rd to measure mine.

 

[1985_K5_Silverado]

You could call a buddy and have one of them run by with a tape and measure the door. If your memory can tell you about how much the fully open door takes away from the opening, that should get you pretty close.

 

[BozoWise]

It is 80" clearance on the door for sure the questionable measurement is the height of my blazer.

 

[90K5]

my Blazer with a 3" lift and 33's cleared with a few inches to spare...

 

[BozoWise]

Well that is promising. About another week until I get back.... counting the days as this has been a long roadtrip.

My house is over on 108th east of Indiana. Your more then welcome to come by for a beer or wrench session anytime. I need to line up a new group off guys near Lubbock to go wheelin with since I am closer now to Amarillo wheelin the NM wheelin.