Molten image design diff covers

[garlicbreath]

Anyone know what happened to Molten image design? They made those crazy diff covers with faces and whatnot. Was tested by a 4x rag a few years ago and held up to Curries tracked dozer. I want one with boobies on it!!!

 

[jekbrown]

haven't seen an add in a little while. Not really a surprise.. if I remember correctly their covers where not only strong... but VERY heavy and very expensive (ie over $300) too. Personally I'd go with a GLO, DIY or Off Road Overstock cover...

j

 

[garlicbreath]

I was wondering about how much a cast stainless steel anything would cost. But in todays world of bling and fake hummer excess you would think they had a market. Are they still around and just lo key or did they go under?

 

[jekbrown]

I dunno... but here is their contact info...

[FONT=Arial, Helvetica, sans-serif]Molten Image Designs
1575 W. 1600 South
Springville, Utah
Telephone 866.489.7287
www.moltenimagedesign.com[/FONT]

j

 

[garlicbreath]

Their website hasn't worked in a week.