More Roll Cage Pictures

[jfortner]

Had a chance to take some more photo's of how I did the floor bracing for the roll cage to tie it all together. I am planning on running five bucket seats. Two up front; one in the middle with the legs overhanging the step; and two in the back just slightly back from orginal. That is what drove the placement of the bracing on the floor that I used to support the cage. Used 1x1 and 2x1 square for the base. Welded it to the floor and I am fairly certain it is not going anywhere.

John

 

[CDA 455]

Nice job so far !

What's the vertical square tubing around the wheelwell/side wall for?

 

[jfortner]

I plan on using 1/4" plywood covered with batting and vinal and laying it across the tubing and then screwing it in for side panels back there. Having a couple of access holes near the top and it should give me a place to toss all the little extras you need to carry all the time but don't want laying out in the open. The right rear is fabbed up to allow me to install a rear heater for the winters here.

John