goochieman83
1/2 ton status
Mine might need to go down some then, cv driveshaft in the rear and axle rotated 1 degree below driveshaft angle.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
More vibration fun!
- Thread starter goochieman83
- Start date
They typically recommend 1-2 degrees down from 0 with a CV. Mine is right at zero, but I have an anti wrap bar so it doesn't change.
Mine is at 1 degree down from driveshaft (14 pinion, 15 driveshaft). I did try last night shimming it 1 more degree (15 and 15) with no change in vibration.....if that helps you.
goochieman83
1/2 ton status
Yeah I figured I wouldn't get any vibes with the cv. Might try shorter shackles and slightly stiffer springs. Still has factory rear springs and 6" shackles.
Have a GoPro?
Recently, i started getting some weird vibrations, thought it was the u joints. Swapped them out, no change. Finally zip tied the camera to the tranny cross member, and wala! My slip yoke is wobbling carrier bearing is shot and getting spring wrap. 15 seconds of film goes a long way.
Recently, i started getting some weird vibrations, thought it was the u joints. Swapped them out, no change. Finally zip tied the camera to the tranny cross member, and wala! My slip yoke is wobbling carrier bearing is shot and getting spring wrap. 15 seconds of film goes a long way.
skyhigh4by
1/2 ton status
Awesome idea! I'm gonna have to give that a try
goochieman83
1/2 ton status
Unfortunately no, thought about that though.
goochieman83
1/2 ton status
Haha, I thought the same thing but I paid 400 for my phone so that isn't happening.
