Moving/ Shop Clean out
All prices are OBO, all items are located in Glen Burnie, MD
I don't mind shipping smaller stuff in flat rate boxes
Dana 60 Crossover Arm- $80.00
The same one is for sale on PartsMike for $150
http://www.partsmike.com/store/store...on=show_detail
Dana 60 Cast Kingpin Spring Cap- $15.00
Dana 60 4” Steering Block With spring spacer and studs- $35.00
Like this one- http://store.4wheelingplus.com/prodd...artner=froogle
New Dana 60 Kingpin Bushings $5
Stock Dana 60 Cover: $5
4” Old Man Emu XJ Coils- $80
I don’t have any info on them as I bought them used but was told they were 4”. The guy I bought them from had these and a 1.5” spacer and traded out for rusty’s 5.5” coils and the ride height was .5” lower after the coil swap. I think they are 4” coils but I cannot verify that.
4” Lifts Blocks- 2.5” wide- $30
Dana 60 30 spline Warn Premiums- $100
Used But in Great Shape
16 Gallon Poly Fuel Cell- $120.00
7.25” 3/8 plate shackles, 9/16 bolt holes- $20.00
Quadrajet Carb, Worked When pulled- $65.00
Edelbrock Torker II SBC intake manifold- $75.00
For Square Bore Carb, Wire wheeled and cleaned up
Stock SBC Spread Bore manifold- $20
I’ll add more parts as I find them, Thanks for looking.
All prices are OBO, all items are located in Glen Burnie, MD
I don't mind shipping smaller stuff in flat rate boxes
Dana 60 Crossover Arm- $80.00
The same one is for sale on PartsMike for $150
http://www.partsmike.com/store/store...on=show_detail
Dana 60 Cast Kingpin Spring Cap- $15.00
Dana 60 4” Steering Block With spring spacer and studs- $35.00
Like this one- http://store.4wheelingplus.com/prodd...artner=froogle
New Dana 60 Kingpin Bushings $5
Stock Dana 60 Cover: $5
4” Old Man Emu XJ Coils- $80
I don’t have any info on them as I bought them used but was told they were 4”. The guy I bought them from had these and a 1.5” spacer and traded out for rusty’s 5.5” coils and the ride height was .5” lower after the coil swap. I think they are 4” coils but I cannot verify that.
4” Lifts Blocks- 2.5” wide- $30
Dana 60 30 spline Warn Premiums- $100
Used But in Great Shape
16 Gallon Poly Fuel Cell- $120.00
7.25” 3/8 plate shackles, 9/16 bolt holes- $20.00
Quadrajet Carb, Worked When pulled- $65.00
Edelbrock Torker II SBC intake manifold- $75.00
For Square Bore Carb, Wire wheeled and cleaned up
Stock SBC Spread Bore manifold- $20
I’ll add more parts as I find them, Thanks for looking.
