My brain! What size is stock FUSH bushing?

[NorCal_Chris]

So my FUSH bushings are toast. i wanted to get the nice diy4x FUSH but i dont have 70 bucks right now for em. So i want to just replace the bushings. I cant for the life of me figure out the size. My bushings in my 52s are shot too at the shackle, and i know i need a 1.5 bushing for that. Is the top a 1inch? I have no issue with drilling my shackles out for a bigger bolt up top if i can swing it either.

Basicially im going to get this for my 52 spring

and i just need to know what to get for the factory fush.

 

[NorCal_Chris]

looks like lmc has the same bushing listed for stock front spring on bottom, and on the fush.
So if i go and ask for bushings for stock front springs will that give me the right bushing?

 

[big dan]

http://www.energysuspensionparts.com/proddetail.asp?prod=3%2E2111

straight from enerysuspension, I think the size is 1.1" though

I also drill the bushing sleeve and shackle out to 1/2" and use 1/2" bolts instead of the factory 7/16" bolts.
When I put longer shackles on the front (which I assume you did since you're running 52s) I started popping the bolt heads off of the 7/16" bolts. Havent popped a 1/2" bolt yet.

 

[dremu]

straight from enerysuspension, I think the size is 1.1" though

I happen to have my factory FUSH's sitting around, and yep, the tube is more like 1.1" ID, fwiw.

-- A

 

[cybrfire]

I think most places you'll order that from would refer to it as a 1 1/8", but yeah, You're right there.