Need a cruise control part - GOT ONE!! Yea it WORKS!!!!

[badmix]

i need the bar (linkage) from carb to vacuum thingy, no junkyards here have k5s or 'burbs, ill cover shipping.

thanks

oh its 84 k5 carbd

 

[bronc3buster842001]

I may have one.

 

[badmix]

I may have one.

Lemme know if you do. Thanks

 

[desertrat67]

I will go pull my box of crap out tomorrow and look for you.

If my wife was here I would run up to the junkyard for you.

 

[Metrodps]

this help?

this is from a newer book but better picture.

 

[badmix]

Thanks.

from that last pic,

I need #13, 14, 15, 16 & 17 to mount it up, but with just 17 I could probably make due.

 

[desertrat67]

Damn, mine is a 6.2, and is definately a little different or I would rip em off and send em your way.

 

[bronc3buster842001]

Sorry man haven't had time to look to see if I still have one. Been workin like a dog and i blew the motor up in mine. Ill try to find it this weekend.

 

[badmix]

Ok, I appreciate it. The junk yards here dont have anything remotely close to our years or vehicles. Ive seen one K5 in the last 10 years and it was gutted to a shell only.

 

[bronc3buster842001]

I just looked for this. I found one but think it came from a v-6. It looks a little to short.

 

[Teck]

Should be able to get one off any late 70 to 90 GM truck not just a K5, should be all about the same.

 

[84zz4ss]

I have one from my 90 TBI Blazer. I also have one from a 454 carbed C20. I will check the lengths. Do you have a dimension from the diaphram to the carb?

 

[badmix]

I dont have any dimensions but can try and get some. Are the CC arms adjustable?

 

[84zz4ss]

Yes they are adjustable. Get a dimension from the diaphram to the carb pin.

 

[Teck]

I got mine on the bench at the shop. Can get a pic and dimensions tomorrow.

 

[badmix]

Thanks everyone, I ended up finding my old rod that I had taken off. woohoo. surprised I kept it. lol.

now I need to figure out how this will install on a HOlley 570 street avenger. Anyone??

Is the CC a push or pull design?

Anyone with an 84 stock motor with cruise still hooked up, could you get a pic of the drivers side motor, and how the CC is connected and if there is a bracket on the block that needs to be installed.

thanks

 

[desertrat67]

The diaphram should pull the throttle linkage. Or at least that is how it works on a 6.2.

 

[Metrodps]

now I need to figure out how this will install on a HOlley 570 street avenger. Anyone??

Is the CC a push or pull design?

Anyone with an 84 stock motor with cruise still hooked up, could you get a pic of the drivers side motor, and how the CC is connected and if there is a bracket on the block that needs to be installed.

thanks

Please refer to http://coloradok5.com/forums/showpost.php?p=2581286&postcount=5

 

[badmix]

Ok. I think ive got it figured out. I just need holley # 20-36, its a ball stud that replaces my existing throttle stud and allows both throttle cable and CC bar to fit.

 

[badmix]

Local speedshop had the right part, put it on and now ive got working CC. pretty cool.