Need a new engine management harness

[4xcrazy]

I'm looking for either a brand new, or a pretty good condition engine harness for my '89 Burb, TBI 350.

I have done a small bit of researching, found one so far, but if anyone has any other leads as to where to get this thing, please let me know.

OR

If you happen to have one that's not all cut up and in pretty decent condition, FOR the '89, let me know what you want for it.

All I need is the harness coming from the computer to all the engine components, BUT, the thing is, I took TWO other harnesses with me I acquired in the past, neither one had the same fuse panel connectors and I really wasn't in the mood to deal with rewiring and figuring out color codes. thinkin they were older or something, not sure.

I'm planning on taking another trip back to Indiana shortly after the beginning of the year and attempt to get this damn thing running.

I want my truck

Thanks.

 

[readymix]

I have the one from my truck. Just missing the section that goes from the fuse block to the headlights.

 

[readymix]

Edit: it is from a 1987 if that matters...

 

[imiceman44]

I'm looking for either a brand new, or a pretty good condition engine harness for my '89 Burb, TBI 350.

I have done a small bit of researching, found one so far, but if anyone has any other leads as to where to get this thing, please let me know.

OR

If you happen to have one that's not all cut up and in pretty decent condition, FOR the '89, let me know what you want for it.

All I need is the harness coming from the computer to all the engine components, BUT, the thing is, I took TWO other harnesses with me I acquired in the past, neither one had the same fuse panel connectors and I really wasn't in the mood to deal with rewiring and figuring out color codes. thinkin they were older or something, not sure.

I'm planning on taking another trip back to Indiana shortly after the beginning of the year and attempt to get this damn thing running.

I want my truck

Thanks.

I have an 89 TBI 350 very low miles and unmolested.
I am putting a 454 in it before the end of the year.
I would be willing to sell the harness to you and maybe get your old one so I can go thru it and maybe fix it for keeping it with the engine.

 

[4xcrazy]

I'm not entirely sure that is the problem, but it's pretty much the only thing I haven't changed, besides the computers chip, I even swapped out the computer module with a couple...

This is the one that randomly loses signal pulse or power to the injectors, left me stranded in St. Louis on one attempted trip back to Arizona with it.

Replaced several distributor modules, last attempt was a completely brand new distributor, not rebuilt. pulled the harness a couple of times to inspect it, all the loom has long been gone, but I never found any major bad sections. Anything that looked questionable, I resoldered or connected with fresh wire surfaces.

 

[4xcrazy]

iceman..

We are actually heading to L.A. area near Christmas time, to hit up Disney for a weekend and pick up a few things my uncle is giving me, how much would you want for it?

Readymix, I believe the ones I had taken with me to attempt replacement were of the same year. Don't think it would work easily. Not without a bunch of splicing and whatnot anyways.