Need a NP205!!

[armyfiredawg]

I am looking for a NP205 to finish my doubler project. Needs to be out of a TH400 application and have a fixed rear yoke. Anyone???

 

[sweetk30]

also needs to be short input also if i recall. like the old style fig 8 adaptors used.

hope this helps ya good luck.

 

[jekbrown]

you have any machinist buddies? Its almost always cheaper to buy a 10/27 spline np205 locally (craigslist, $100 or less) and just have the input bored for the larger bearing/input than it is to get the blingin, uncommon and very sought-after th400 version. I'm using a 31-spline ford input in mine... basically got it for free after selling other parts off the 2 cases I got.

j

 

[armyfiredawg]

I was hoping i didn't have to go that route but i can't find a 32 anywhere!! Its rediculous! Unless i want to pay 300 bucks for one in kansas. I do have a uncle that works in a machine shop of somesort. I think i will give that a try. Thanks for the advise!!

 

[muddybuddy]

yep same here either cant find them, or people askin $$$$ for them

 

[K10ANDYKHAMNIC]

there is a bearing you can use with the smaller bore dia and the th400 input .