CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Need help with radio wiring

k51977blazer

1/2 ton status
Joined
Feb 11, 2007
Posts
190
Reaction score
15
Location
Cocoa Florida
I have 1976 blazer the problem I’m having it has a has a aftermarket wiring harness these are the wires that I have for the radio I believe, 2 red Wires one black wires assuming the black is ground where would I put the yellow wire coming from the radio and red wire coming from the radio

31A1F86D-71EE-4F33-8E60-67761F167512.jpeg
 
You need to check to see what the 2 red wires do. Is one always on and one key on? Never assume any thing on wiring you did not install. Check the black to be sure it is a ground.
 
That purple one should be the 12 volt crank power to starter solenoid. It should be connected to the nuteral safety switch.
As @ktmoutfront says confirm this with a volt meter or test light.
 
That purple wire is on the wrong side of the firewall to run to the starter. What is the other end attached too?
 
goes from ignition switch to neutral safety switch to bulk head connector, to starter
 
Got the radio hooked up everything is good test light was my best friend I’ll trace the purple wire tommorow and see where that goes thanks again everyone
 
I am guessing that that purple wire is for something else. Added on. To long for under the dash for factory application.
 
Top Bottom