need some help

[BlackBourbon]

well i am finishing up the 1-ton swap on my burb and ran into a problem. i bought the 447 ujoint to go from 10bolt driveshaft to 14bff rear end, went to hook it up......
my dumba$$ didnt check first and I have a 1410 yoke in the axle. Where would I find a weld on 1410 yoke for my driveshaft? Or is there an easier solution?

 

[BlackBourbon]

 

[oatsk5]

i take it your truck was half ton you might try a driveline shop

 

[shaun89]

im not sure how much a 1410 yoke would be, but my buddy got a shaft made at a local shop and a weld in 1350 yoke or "bung" was only $25

 

[Hogback Fabrication]

If your 14 bolt really has a 1410 yoke on it, your best bet is to find a 1410 weld yoke that will fit the diameter tubing that your driveshaft uses.

Any local driveshaft shop should be able to get one, Google shows a bunch of places that will sell them, high angle driveline comes highly recommended and he'll be able to help you out.

 

[BlackBourbon]

Thanks guys! I'm good at wrenching on stuff and can take apart and put back together just about anything but this is my first build like this. Experience is one of those things you don't get till right after you needed it right? haha