New t-case crossmember

[zcarczar]

I figured since my crossmember was broken, and was also a land anchor since the t-case was clocked I would make a new one. Heres what I came up with so far, Its based on the 4x4 iron design but I improved it a bit. It will run the crossmember in the back with the lights on it to keep the skid plate from acting as a lever. The gray is gonna be how the skid runs. Im gonna try and get the skid done tomorrow after work. I would have done it tonight but I ran out of day light, and I needed to get some hw done for my wonderful college classes.

 

[zcarczar]

Done, except I still need to cut the edges off the angle iron.

 

[blackblazer717]

looks awesome, i nee how you bolted the x-member to the case looks good

 

[RustBuket]

Once the angle iron is trimmed down, it should sllllllliiiiiiide right over anything.