CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
New toys...........now I can go play with myself!
- Thread starter dontoe
- Start date
roadnotca
3/4 ton status
I was having a hard time trying to figure out what you got there, but now I see a ReadyWelder II. Only thing stopped me from ordering today was I'm busy with front axle, and I wanted to think about it over the weekend. What do you think of that welder Don? Do you have an HD welder in the shop also? I haven't been able to determine if the RWII can cut at all (with gas).
Thanks
Who let 53 years go by without telling me?
Thanks
Who let 53 years go by without telling me?
roadnotca said:I was having a hard time trying to figure out what you got there, but now I see a ReadyWelder II. Only thing stopped me from ordering today was I'm busy with front axle, and I wanted to think about it over the weekend. What do you think of that welder Don? Do you have an HD welder in the shop also? I haven't been able to determine if the RWII can cut at all (with gas).
Thanks
Who let 53 years go by without telling me?
Welds 1/2 inch with two batteries, 3/4 inch with three batteries. Just opened it near dark, so I just got the wire spool in it and made sure it work on a piece of chain on one battery..............yep, welded it, sure enough, duh!!!
About 50 inches of weld from two batteries, according to the fellow NC4X4 member I ordered it through. Though I do have an old "large" stick welder! I wanted a mig welder for thin stuff and I weld "prettier" with a mig!
roadnotca
3/4 ton status
Chip Price?dontoe said:
roadnotca said:
Yes sir, fine fellow and has a kick a$$ commercial machine shop as well.
roadnotca
3/4 ton status
Thanks Don.dontoe said:
Trigger Creep
Registered Member
... and I thought I was ahead of the curve by carrying a tube of JB Weld 
roadnotca
3/4 ton status
Trigger Creep said:... and I thought I was ahead of the curve by carrying a tube of JB Weld
Geargrinder
1/2 ton status
I LOVE mine, Ive done all kinds of stuff with it. But I have had problems geting it to feed out the flux core wire on just one batt. Other than that it's a great welder! (just ask the Heep driver from my last outing that is still driving on the welds
)
)
roadnotca
3/4 ton status
337,000MI on the ORIGINAL 350cid!!!!!!
Must of been built on a Wed.
Must of been built on a Wed.
