Tweetysuarus
1/2 ton status
You got to remove the dist and then remove the gear. Buy a new pick-up coil and it has directions on how te replace it!
Bill
Bill
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
no spark|? help!!
- Thread starter bryguy00b
- Start date
bryguy00b
3/4 ton status
i figured that, but im playing with another one i had laying around trying ot take it of so i know how ot do it on my truck. how do u get the gear of? is there a pic u push through there or somethin??
Hossbaby50
3/4 ton status
You have to pull the distributor out of the motor, drive the roll pin out of the distributor gear on the bottom, remove the distributor shaft and you should be able to get to the pickup coil.
Make sure you mare the exact position of the distributor before you pull it out though.
harley
Make sure you mare the exact position of the distributor before you pull it out though.
harley
Tweetysuarus
1/2 ton status
[ QUOTE ]
You have to pull the distributor out of the motor, drive the roll pin out of the distributor gear on the bottom, remove the distributor shaft and you should be able to get to the pickup coil.
Make sure you mare the exact position of the distributor before you pull it out though.
harley
[/ QUOTE ]
Yes it's quite important that you mark the gear and shaft so you can put it back in the right position.After you get the shaft out then there are three screws that hold the pick-up coil in place.
Bill
You have to pull the distributor out of the motor, drive the roll pin out of the distributor gear on the bottom, remove the distributor shaft and you should be able to get to the pickup coil.
Make sure you mare the exact position of the distributor before you pull it out though.
harley
[/ QUOTE ]
Yes it's quite important that you mark the gear and shaft so you can put it back in the right position.After you get the shaft out then there are three screws that hold the pick-up coil in place.
Bill
Hossbaby50
3/4 ton status
use a flat punch or something that is the same size as that roll pin and tap it out with a hammer.
Not sure if it's a "feature" of some roll pins or not, but if the roll pin seems hard to get out, try from the other side.
I have had a few instances working with GM stuff that the roll-pin seemed to only go in from one side.
I have had a few instances working with GM stuff that the roll-pin seemed to only go in from one side.
bryguy00b
3/4 ton status
well, i swapped cap/coil from my dads truck, and put a good moduale in it, and the roter looks fine, and still nothin..so guess the next thing ot check is the pickup coil...
