np 203 Selector Levers

[Bevis]

I've spent several days searching the net for an answer. Can anyone tell me what the lever selectors are (mainly the inner), on the side of the 203.

Have a '79 K5 350/350/203 that the PO did a diy twin stick on when the original 4wd shifter malfunctioned...The diy work, but would like to know what the selections are. I'm sure the outer one is Low-Med- High.

Thanks for the help.

 

[sweetk30]

outer big shaft body up next to case body = front/rear lock .

inner small shaft body inside other = range high/low.



I know if from building doubler setups . the inner small is the only one used for the front gear reduction / range box .

hope this helps and welcome .

better just stop here first next time you have a question

 

[Bevis]

The part where #8/9 attaches to.

 

[sweetk30]

like said . lever / shaft close to tcase body = front /rear lock .

the arm / inner shaft outside away from tcase body = range control low/high .

 

[Bevis]

SweetK30... Thanks for the help. I'm at work on the computer and didn't see your 1st reply until after I posted the pic. Thanks again.

 

[sweetk30]

no prob buddy