YZEATER
1/2 ton status
can the front output bearing be replaced without removing the t-case from the truck?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
np205 question
- Thread starter YZEATER
- Start date
YZEATER said:
Yes.
Remove the nut holding the yoke/flange, remove yoke/flange, remove four bolts holding bearing retainer in place, use a small screwdriver to get behind snap ring and pull bearing and snapring out as one piece. Just be careful as the output shaft will want to fall. It shouldn't move far enough to knock anything out of alignment, but be careful. There is also a thrust washer behing the bearing that may come out with it...
YZEATER
1/2 ton status
thank you very much. i didn't want to have to lift it again.
