NWF Dana 60 30/35 Spline Drive Flanges

[NorthWestFab]

We have been selling D60 35 Spline Drive Flanges for a few Years and have had great success with them!

Recently we have been getting calls for 30 Spline Drive Flanges so we decided we would give them a try.

They feature everything our 35 Spline Drive Flanges do such as 8620 heat treated slugs, Black Anodized Caps, Stainless Hardware, O rings, and Special Spiral Snap Rings; without the cost of upgrading your stub shafts.

(35 Spline Drive Flanges Shown)​

Both the 30 Spline as well as the 35 Spline Drive Flanges sell for $225.

For a quote or to place an order call us at 250-248-6024.

-NWF

 

[Smokinthehippies]

is there any difference between the two other than the slug?

as in could they be used in a 30 spline setup now, and now just buy replacement slugs later when stepping to the 35 spline setup?

 

[NorthWestFab]

is there any difference between the two other than the slug?

as in could they be used in a 30 spline setup now, and now just buy replacement slugs later when stepping to the 35 spline setup?

Everything else is the same, so yes you can upgrade later!

Kris

 

[4X4HIGH]

The question is though, how much are just the slugs by themselves?

 

[Smokinthehippies]

The question is though, how much are just the slugs by themselves?

Kinda the point I was getting to as well ...

 

[NorthWestFab]

The question is though, how much are just the slugs by themselves?

We sell the slugs for $69ea

Kris