oba help

[sweetk30]

well i have looked for good info on oba and use of york's and full serp belt. well nothing much other than side hung bracket for v belt or bracket for a/c spot on full serp thats fine by me.

i have 2 yorks to check for the output size then will look for my stuff from there.

been thinking of kilby but he is $$$$$$$ and i think overpriced.


what do you guys got ? this will be for 2 arb lockers / tire fill up's / other toys n tools.

 

[folkenheath]

I have a york with serp on my BB. Made the bracket out of 6061 aluminum. Have a 3 gallon tank in the back. With a quick connect under the hood and the rear bumper. It's controlled by a pressure switch from the air-bagged low rider crowd. Had to use an 8 groove puller so the grooves were further back, otherwise I would have to mount it way out past the cyl head. I used a stamped steel 1994 serp bracket on the drivers side, and made one for the pass side replacing the factory cast iron bracket.

The york works fast, it fills the 3 gallon tank from 0 - 125 psi in about 20 seconds. And just at idle, if I hold the air nozzle wide open it will maintain 70 - 80 psi, if I had a high idle it would be even better.

If you can't see the pics here you can see them in my album.