OK, now can someone measure the center hole on a D60 rotor for me?

[mofugly13]

Just like the title says. I need the center hole measurement on a D60 rotor. Looking for 5.400". Thanks fellas.

 

[mofugly13]

Anyone? /forums/images/graemlins/dunno.gif

 

[readymix]

My truck shoule be parked in the garage this weekend for a axle overhaul / crossover steering install. I can get it for you then

 

[mofugly13]

Bueller.............................Bueller........................?

 

[big83chevy4x4]

got to like autozone and have them pull one off the shelf and measure it.

i would measure one seeing how there is so little to do round here, but i have no d60, anyone wanna give me their's? /forums/images/graemlins/deal.gif /forums/images/graemlins/whistling.gif

 

[JK5]

Hey Matt...

I have one on the shelf...
I'll get you a measurement tonight!!! /forums/images/graemlins/wink.gif

 

[mofugly13]

Hello.....Hello......Hello, is there anybody in there???

My local parts stores dont have rotors in stock, can someone PLEASE measure a D60 rotor for me?

 

[readymix]

I am going out to play in the mud tomorrow morning then i will fire up the pressure washer and get her all cleaned up and ready to go in the garage. The first thing i will do is the front axle and i will get you the measurement ASAP. Sorry about the lag time.

I want to start working on the truck but at the same time i also want to wheel the piss out of it. Decisions, decisions...... /forums/images/graemlins/thumb.gif

 

[mofugly13]

C'mon, Fawkers

NOBODY has a D60 rotor siting around???

 

[readymix]

My plans were put on hold when my neighbor exploded his rear diff. As soon as we get it fixed my heap will be OOC and in the garage for measurements.

 

[hawk368]

I'm doing bearings on my buddies truck right now. I still have one off. ( got to cold & dark to finish ). I'll measure it in the morning when I get there. I should have it posted by 2:00 pm ... But, which ( hole )are you refering to ? /forums/images/graemlins/cool.gif /forums/images/graemlins/thumb.gif

 

[mofugly13]

I need a measurement of the hole through the rotor where the hub goes. I donno if the rotor and hub need to be separated to get a good measurement. /forums/images/graemlins/dunno.gif