with no welding required!!ill have a tech article later but now my big question is im running 32 spline 1410 np205 yokes front and rear and i need new output seals to clear the yokes (the old seals are to small)..anyone got a part number
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
ok so i did the dodge/chevy 208..
- Thread starter twoslo4five0
- Start date
so i found the rear (should have serched 
)
http://www.autozone.com/R,3026/init...partType,01056/shopping/partProductDetail.htm
still need the front though is it the same??
)http://www.autozone.com/R,3026/init...partType,01056/shopping/partProductDetail.htm
still need the front though is it the same??
bump?
Stomis
Professional Amateur
Lol fer serials?
When I had my SYE'd 241 the OD was the exact same on the front and rear outputs. The difference was the front used a double lip seal and the back used a single. After realizing this I put double lip seals front and back no problemo.
When I had my SYE'd 241 the OD was the exact same on the front and rear outputs. The difference was the front used a double lip seal and the back used a single. After realizing this I put double lip seals front and back no problemo.
I found the part number. I will post a pic of it up when it comes in. It has a large shaft DIA to fit the larger yokes.
Pics?
I had a Dodge NP208 "bought" but the kid threw it in the iron before I got there.
Martin
I had a Dodge NP208 "bought" but the kid threw it in the iron before I got there.
Martin
I did a tech write up a while back, here is the link
http://coloradok5.com/forums/showthread.php?t=246154
http://coloradok5.com/forums/showthread.php?t=246154
Thanks. I wish I would have nabbed that Dodge NP208 before he threw it away.
Martin
Martin
