gotblazers
1/2 ton status
So i just picked this thing up. Heres what i know about it. It is an 88 3/4 ton chevy single cab longbed pick up. It has a Tbi 350 motor which i will be keeping and i believe it has a 700r4/np241 combo based on the year and the appearances of the truck. This is a 4wd IFS front set up so the TC is driver drop. The truck has 237k on it and it was a ranch truck in its past life so the body is pretty damn beat although minimal rust from what i could see initially. On that note since its a ranch truck this thing has apparently been out of the system for over 10 years and has no plates nor title so it is not good for anything but parts and scrap. I ran the vin to make sure its not stolen and it came up good.
The parts im definitley keeping atm are...
1.TBI 350 motor and everything neccessary for the swap
2.The IFS front 4wd assembly
Parts which may interest you guys
6 lug aluminum rims
14BSF 6 lug rear end
Gooseneck hitch in the bed
The truck tool box as shown in the pics
Besides that, if your interested in anything just let me now and we can make a deal. Most of this will be going to scrap within the next few months if a buyer doesnt come up for it.
The parts im definitley keeping atm are...
1.TBI 350 motor and everything neccessary for the swap
2.The IFS front 4wd assembly
Parts which may interest you guys
6 lug aluminum rims
14BSF 6 lug rear end
Gooseneck hitch in the bed
The truck tool box as shown in the pics
Besides that, if your interested in anything just let me now and we can make a deal. Most of this will be going to scrap within the next few months if a buyer doesnt come up for it.
. Dont wanna let the cat out of the bag on my next project before i get my current project worthy of some good wheeling on the weekends. living 10 min from HH with nothing to wheel is 
. Thanks for all your advice and knowledge on helping me figure out how to do this whole parts truck thing btw 
.
. Whats your interest?
