post your anti wrap bars

[Jishory]

i have been fiddling with cad designing one, need some inspiration. i cracked my yoke real nasty friday for the last time because of my axle wrap. i ordered diy4x's bracked for my axle tune and im going to mock the rest up from there

 

[dleroy43]

you could turn your pinoin down a few degrees so it will wrap up into a useable angle instead of wraping into a bad angle. Yours is starting in a bad angle already.

 

[pismorat]

Here's a few pics of mine, I got the bushings and Jonny Joint from PolyPerformance and I used 1.75x1.20" tubing. The cross member is made with 2" square tubing, it does hang down a bit but I have never snagged it yet.

 

[Jishory]

i got some rough dimensions down