Pressing wrist pins out of con rods...

[mofugly13]

I have a set of connecting rods with pistons attached, and I want to separate the two. The pins are pressed into the con rod. What's the best/easiest way to press the pins out, for a guy without a shop press? I'm gonna scrap the pistons but I want to use the rods for a non-motor related project.

 

[4X4HIGH]

Drive across the bridge into Fremont, meet a fellow CK5er while he presses them apart for you while you wait, watch, learn and then we can have lunch, then return over same said bridge back to the City.

We can even bead blast the rods so they are nice and pretty for whatever your project is.

 

[rdn2blazer]

Drive across the bridge into Fremont, meet a fellow CK5er while he presses them apart for you while you wait, watch, learn and then we can have lunch, then return over same said bridge back to the City.

We can even bead blast the rods so they are nice and pretty for whatever your project is.

THAT sounds like a GREAT deal you should'nt pass up mofugly, Very cool offer indeed.

 

[mofugly13]

Thanks 4x4High, I might take you up on that when I get a chance. You open on weekends?

 

[4X4HIGH]

Thanks 4x4High, I might take you up on that when I get a chance. You open on weekends?

I am here on saturdays from 9-3