Kain
3/4 ton status
Does anyone have these? do they ride good? or is it a brick?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Pro comp springs rear leafs?
- Thread starter Kain
- Start date
Nope... ORD custom for me. SD springs is another option
the one set I rode in, I wasn't overly impressed.. bit rough IMO, but that was prolly 15 yrs ago...
I have the 4" rear set on my crew cab. Very not bad. Great price point, lifetime warranty and better spring rate than most and definitely better than the 1 ton springs.
I wheel the front 6" on my blazer.
But they aren't my go to if you want ride quality being top of the list for half tons and blazers.
I wheel the front 6" on my blazer.
But they aren't my go to if you want ride quality being top of the list for half tons and blazers.
I ran a set I bought used for over 7 years. They worked well enough. Maybe you could say they are the "okayest" springs I've run.
what size lift are you looking for?
Kain
3/4 ton status
already a 4 inch but have blocks was looking at replacing them and get all spring and ditch the blocks
I would look at a flip kit if you're OK with the current ride quality.
Kain
3/4 ton status
Springs on there are shot and want to get rid of the lift blocks
i figured that is what you had. i was asking because I have 2 or 3 sets of 6" lift rear springs.
Kain
3/4 ton status
dont want 6 inch or would take you up just looking to get rid of blocks and not shackle flip
Kain
3/4 ton status
ORD does sell Tuff County. I got my fronts from them.
I'd run TC's before Pro Comp...
backordered and not available from ORD last time I looked.
Even though I ordered from ORD mine shipped directly from Tuff County.
yep, me too.
Kain
3/4 ton status
Thanks for the replys guys
I ran a set on an 89 K3500 that I SAS'd, used their 5.5" and were super soft. I had to put extra leaves in to firm it up.
ORD quit carrying Tuff Country.
