Progress is being made...slowly. :O

[Zeus33rd]

A trip to the junk yard for an alternator, idler pully, misc bolts and a tensioner pulley and this is how it sits. I need to find a power steering pump that will fit, figure out exhaust/headers and fuel system and the big stuff is done. Getting closer. #8.1POWA

Need a pump that will fit in there-

And interior. It's like....15% done. Will have bucket seats up front, with console/dash extending to the back of the front seat. Will stay bench seat in the back. Found an '07 cummins 4 door rig in the junk yard today...those seats are really nice. Might snag those up. The transfer case shifter extension is a 35mm wrench I bought at the bargain tool store for $9.

 

[wetoolowdingbangow]

Looking good. Did you make that engine crossmember? Im getting ideas as I need to make one.

 

[Zeus33rd]

Yes, I made the cross-member. The bottom section is 2x3x.250, the angled parts are 2x2x.250.

 

[Zeus33rd]

I think this is what I need for a power steering pump.

http://www.pscmotorsports.com/motor...ormance-p-series-pump-reservoir-kit-1805.html

 

[swettysblazer]

Looks good man!

 

[sweetk30]

reg old gm pump should fit in there fine .

wen I went v-belt to serp setup my 79 pump bolted in that same stle bracket minus the need for American thread bolts .

if you want remote resivor and hydro boost look fo a van . they had about the same setup as in the psc pic . and most vans had a van specific hydroboost to clear the firewall /hood . but the will swap over.

the resivor bolts to the coresupport .

 

[wetoolowdingbangow]

Awesome thanks for the pics!

 

[Phil513]

Transfer case shifter is badass.

 

[Bent77]

Love the evidence on the frame from your tire grooving

 

[wetoolowdingbangow]

Hey you!


Yeah you!

Hows everything going? Hope youre doing well.