I installed a serpentine system off a 90k5 on my 77 K 10, Is there any special procedure to install the pulley on the crank? I'm not a motor guy....Thanks
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
pulley install
- Thread starter newoldscottsdale77
- Start date
unbolt big center bolt then 3 smaller bolts.
remove old v-belt pulley
install new serp pulley
reinstall all bolts .
and tourqe to spec.
remove old v-belt pulley
install new serp pulley
reinstall all bolts .
and tourqe to spec.
unbolt big center bolt then 3 smaller bolts.
remove old v-belt pulley
install new serp pulley
reinstall all bolts .
and tourqe to spec.
Thanks, wanted to make sure i wasn't over simplifying it.
If you don't have an impact gun, then re-torque the center bolt after you have the belt on. It helps keep the crank from spinning.
