The zero rate installed correctly for inch forward?
Small bushing in back large in front.
Small bushing in back large in front.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Quick ? On zero rates under the truck right now
- Thread starter brans87
- Start date
Looks like 1.5" offset.
That said, once the center pin is seated in the axle will the ZR be centered on the spring pad? It's hard to tell in the pic, looks like the ZR isn't seated yet.
That said, once the center pin is seated in the axle will the ZR be centered on the spring pad? It's hard to tell in the pic, looks like the ZR isn't seated yet.
Got it all installed, now the front sit's to high so going to remove the zero rate and see how it look! Damn glad I did not fully tighten u bolts just snugged them up.
Rear measured ground to fender 41 front reads 43.
Rear measured ground to fender 41 front reads 43.
Are you measuring the body line? The wheel openings are slightly different heights front vs rear.
I measured from the pinch weld on the bottom and my truck and its level, wheel wells make it look 1.5-2 higher in front.
Here you go guys lift installed finally!
Lookin good! 
Thanks guys! It was not fun installing in the driveway but got the big part done.
Still need to install pitman arm,rear shock braces from ORD,front shocks for now to drive it (will do F250 shock towers here shortly),and Torque all bolts.
Think that will cover it besides finding tires.
Still need to install pitman arm,rear shock braces from ORD,front shocks for now to drive it (will do F250 shock towers here shortly),and Torque all bolts.
Think that will cover it besides finding tires.
Still might do ORD sway bar disconnects.
Chevy 8 lug center caps for the H2 wheels.
Squeeze in windstar find and serp setup so can have working ac for the kids and install dash trim bezel.
Make some Tube steps I got for free the are heavy duty work with my K5 (need some tubing and find someone to notch them.
Hoping all this will make wife not hate it SO MUCH.
After this will just hopefully drive with no problems (hoping driveshaft works out). Then I can work on wife's 67 before I find myself in the dog house for a really long time since she hates my K5.
Chevy 8 lug center caps for the H2 wheels.
Squeeze in windstar find and serp setup so can have working ac for the kids and install dash trim bezel.
Make some Tube steps I got for free the are heavy duty work with my K5 (need some tubing and find someone to notch them.
Hoping all this will make wife not hate it SO MUCH.
After this will just hopefully drive with no problems (hoping driveshaft works out). Then I can work on wife's 67 before I find myself in the dog house for a really long time since she hates my K5.
Looks good.
Forgot to tell you I found that battery tray yku asked about. Send me a PM if you're interested.
Forgot to tell you I found that battery tray yku asked about. Send me a PM if you're interested.
We have a 1/4" thick offset plate if the inch is too tall. Doesn't look bad so far though.
