4x4k20
1/2 ton status
i have a freind looking for a rear driveshaft for lwb 3/4 ton . it needs to bolt up to a fixed yoke t case 205 thanks
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
rear driveshaft 73-87 lwb
- Thread starter 4x4k20
- Start date
What tranny? If SM465 is it fig 8 or round pattern? If TH400 is it fig 8 or round pattern? or TH350? I think that makes about 5 different possible lengths... then again is it one or two piece 
And what size Ujoints at each end? I've seen them in 1310 and 1350 and I think some of the mid 80's used S44 or something like that?
And what size Ujoints at each end? I've seen them in 1310 and 1350 and I think some of the mid 80's used S44 or something like that?4x4k20
1/2 ton status
its 2 piece slip joint on single driveshaft iwill post pic later
Mr.Chevy4x4
1/2 ton status
Johnny,
I've got one. I think it came out of a half ton long wheel base with a fixed rear output. I'll get you a picture of it.
Mike
I've got one. I think it came out of a half ton long wheel base with a fixed rear output. I'll get you a picture of it.
Mike
4x4k20
1/2 ton status
here is a pic the front has the slip yoke to the tcase the rest goes to the rear
