Rear of bed/floorpan

[sandy78]

Okay,
Floors have been discussed a lot in the past, but what I need right now is the rear piece of the bed, approx. 3" into the corrugated stuff, with the 1/2" lip rolled on it to attach to the back of the tailpan. Does anyone make a patch panel like this? I don't want to replace the rest of the floor as it is fine. Only rotted out over the tailpan. Maybe sometime down the road for the whole thing but don't have the $ or time for the whole rear floor/tailpan, bedposts project right now. Any help appreciated.

Thanks!

 

[ryoken]

you may also want to look into a new tailpan (the floor support underneath)

http://www.tabcobodyparts.com

http://www.lmctruck.com/chevy_truck_cat_page.htm

http://www.autobodypartsbuy.com/Chevrolet_Blazer.html

the section you want goes forward about 1/2 way down the wheelwell. iirc, theres a left and right rear panel.. you could trim them down as short as you wanted tho..

i actually have a full set of panels down in the garage for when i feel like doing it.. not for a couple years tho..