Rear quarter panels

Discussion in 'The Garage' started by Wicked Wolf Auto, Jul 25, 2006.

  1. Wicked Wolf Auto

    Wicked Wolf Auto 1/2 ton status Premium Member

    Joined:
    Nov 1, 2002
    Posts:
    2,098
    Likes Received:
    79
    Location:
    T-ville, ut.
    Build(s):
    1
    I've tried to buy some from guys parting them out on here but no one wants to chop them off :rolleyes: as it's hard to find them new without spending a fortune and used ones in this area are hard to find rust free. Anyone chopped any off before? I'm planning on watching for a descent set at the salvage yards but want to spend minimal time chopping them off. My plan was to hall my 2000 w. generator and a sawzall and go to town:hack: . I don't think my cordless sawzall would be up to the task:crazy: Any suggestions
     
  2. Wicked Wolf Auto

    Wicked Wolf Auto 1/2 ton status Premium Member

    Joined:
    Nov 1, 2002
    Posts:
    2,098
    Likes Received:
    79
    Location:
    T-ville, ut.
    Build(s):
    1
  3. ryoken

    ryoken Puppy Fabricator Premium Member GMOTM Winner

    Joined:
    Jun 13, 2003
    Posts:
    30,480
    Likes Received:
    2,373
    Location:
    Jersey Shore
    Build(s):
    3
    depends on the year of the donor... earlier k5's are mostly bolt on, only welded at the front and back posts... later models are about 75% welded...

    corded sawzall and genny and you could hack em off in a couple hrs easy... just cut thru the tailpan, over the wheelwell and down to rocker... and across the top post...
     
  4. 1979jimmy350

    1979jimmy350 1/2 ton status

    Joined:
    Mar 24, 2004
    Posts:
    3,070
    Likes Received:
    2
    Location:
    Ann Arbor Mi
    look in the for sale fourm, i have some i want gone
     

Share This Page