bridgeguy
Registered Member
I've searched and searched the forums and have come up with a lot of information about the problems I'm having with the rear window on my '74 K5, but I'm still having issues which maybe someone can help me with:
I've removed the access panel inside and the window is rolled all the way up still. From the outside, the handle just spins and spins which made me think that the
"ears" would be broken. Never actually seen them, just read about them. So, trying to remove the handle to see what I could figure out. Had the wife spin the handle while I was looking at the regulator from the inside and can see the rectangular notch on the inside of the regulator spinning, but nothing else appears to be happening.
Grabbed a 7/16" socket and could get to the nut holding (what I think is) the RH side of the exterior handle on (when looking towards the rear of the Blazer) but I can't get any access to the LH one. There appears to be an access hole in the tailgate sheetmetal, but that doesn't line up with anything on the regulator to allow access through the regulator.
Does anyone have a pearl of wisdom on what I'm doing wrong here?
I've removed the access panel inside and the window is rolled all the way up still. From the outside, the handle just spins and spins which made me think that the
"ears" would be broken. Never actually seen them, just read about them. So, trying to remove the handle to see what I could figure out. Had the wife spin the handle while I was looking at the regulator from the inside and can see the rectangular notch on the inside of the regulator spinning, but nothing else appears to be happening. Grabbed a 7/16" socket and could get to the nut holding (what I think is) the RH side of the exterior handle on (when looking towards the rear of the Blazer) but I can't get any access to the LH one. There appears to be an access hole in the tailgate sheetmetal, but that doesn't line up with anything on the regulator to allow access through the regulator.
Does anyone have a pearl of wisdom on what I'm doing wrong here?

The nut/bolt for the socket to roll down the window, got the other one all figured out...I hope.