Sold Rebuild kit for 10-bolt front axle

[campfire]

Back in 2018 I bought bearings, seals, u-joints, ball joints and TREs for rebuilding my 3/4-ton 10-bolt front axle. Never got around to using them. So they're new in boxes, but some of the joints have surface rust from sitting. And the boxes are beat up from moving around. But the bearings are still sealed up perfectly.

Parts (w/ list prices):
$17 - (1) Dana/Spicer 5-785X (1310, Spicer Life Series, non-greasable) for front driveshaft
$20ea - (2) Dana/Spicer 5-760X (Spicer Life Series, non-greasable) for axle shafts.
$61ea - (2) Dana/Spicer 706116X Ball joint sets
$4 - (1) 10-bolt cover gasket
$9ea - (2) axle shaft seals
$46 - (1) AC Delco 45A0274 Passenger Side Tie Rod End
$46 - (1) AC Delco 45A0275 Driver Side Tie Rod End
$75 - (1) Timken DRK321 Ring and Pinion Gear Installation Kit
$26 - (1) Steering damper (I believe it's AC Delco 509606, but I don't have any paperwork on this one)



These parts would cost $422 new (shipped). I'll sell them for $200 (shipped).

 

[campfire]

Pictures.



I'm not sure how that pair of ball joints got so rusty. I did pull off the boots to show that the insides are still clean and new.











Bearings are still sealed.