Reid Racing Dana 44 Knuckle/ WFO Concepts

[lukefalls]

I bought from WFO Concepts a Reid Racing Dana 44 Right knuckle. Its fits Chevy/Jeep Dana 44 (six spindle studs). It is 100% new and compete. This has never been installed. I bought it for my wife's truck that we sold.

It has a WFO Concepts Crossover arm drilled for TREs. Also, it has all new ARP studs, cones, and washers. It also has brand new spindle studs already pressed in. It also has brand new Spicer ball joints already pressed in.

This costs well over $500 new.

I'll take $400 OBO shipped (bulk rate boxes from USPS)

 

[AJs72K5]

Any reason you went with a 3 hole arm instead of 4? Your post on Pirate mentions the TREs...are you including them too?

Edit: is the tie rod arm on the knuckle (not the crossover arm) tapered for nut up or nut down?

 

[lukefalls]

Sorry, I was not clear. Two TREs are included. One left, one right hand thread. Each has a tube insert and a jam nut. Both have zerk fittings,r ubber boots, castle nuts, and cotter pins. Both are new, never installed.

The TRE sits on top of the knuckle, so the taper is down.

 

[CUCV2]

PM'd you

 

[lukefalls]

PM'd you

Reply sent.