Yes, very nice. Congrats on the progress.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Ryoken's adjustable Welding/Fab Table
- Thread starter ryoken
- Start date
Looks great! Are you going to drill some holes in it so that you can use some of the Strong Man type tooling? Or just leave it nice and flat?
thanks.. 
for now, my intention is not to..... tho I am open to the idea, but I know nothing of the setups.. thanks for the thought, I'll do a bit of research and learn myself some on them...
just have never had a need up to this point.. but with this larger table, I may come across situations where it would be very helpful...
as well as possibly adding a couple receiver hitch tubes for an axle fixture or such is a possibility too..
for now, my intention is not to..... tho I am open to the idea, but I know nothing of the setups.. thanks for the thought, I'll do a bit of research and learn myself some on them...
just have never had a need up to this point.. but with this larger table, I may come across situations where it would be very helpful...
as well as possibly adding a couple receiver hitch tubes for an axle fixture or such is a possibility too..
wow, some of that hold-down clamp stuff looks like it would be VERY handy....
Stomis
Professional Amateur
Stomis
Professional Amateur
Hey why did you have to go to glassborough for the 4x4? I was just curious. Fazzios website says they have 4x4s of 3/8 in stock unless its wrong.
cuz my table is 3 x 4... it was worth the drive and $20 to have em shear it to 3 x 4.. Wall can't do that...
Stomis
Professional Amateur
Ah ok so wall did have a 4x4 then.
correct, as far as I know..
