saggy butt help

[DR]

I'm getting ready to install my newly aquired 3/4 tons in the K5. But, I'd like to take care of a few other things while im in there. As of now, I have a 6" lift with blocks in the rear. And, a case of the saggy butt. I'd like to get rid of the big block, get rid of the sag, and keep the stock springs... So, what my thought is, is to go with a shackle flip and a 3" block. Thus, giving me 7" total lift in theory. So, this should give me the ability to get rid of the way too big bloc, the sag, and retain my springs. Right? Any thoughts?

 

[Hogback Fabrication]

The sag is probably because your rear springs are done for.

I would use a 4" shackle flip and 2.5" lift springs

 

[DR]

any thoughts on a good vendor for said springs?

 

[Hogback Fabrication]

BDS and Tough Country have the best reputation from what I've heard (I was happy with the BDS springs I had)

 

[DR]

Cool thanks! I'll check both out. Thats actually a good idea. Leaves me room to go up with zero rates or what not later in life...

 

[Wrench]

dang, I thought you were going to ask for help with your jean's fitment issues . . . .





















and I was about to offer some advice too . . . .

 

[DR]

According to my wife... I could use a little help there too.