NEK5
3/4 ton status
everything is best offer, you name the price, but keep shipping in mind, if it's neccessary.
gas tank skid plate for k5 with 31 gallon tank, the other side is a little rusty, but nothing that couldn't been clean up
set of 8 lug rollers, they hold air, 235/75r16s decent thread on them, but wouldn't run them on the road (one or two of them are plugged)
charcoal canister from when the truck was a 90 TBI
ford super duty tow hooks
mt valve covers, aluminum, need a little refinishing, but are covered in zinc chromate now
set of kc light covers, 6" IIRC
hood hinges from 90 K5
high liner head liner, not sure how it's installed, never got around to putting it in
ford windstar dual fans, i made metal tabs for the mounts as one was cracked, they just need to be drilled out. it's also missing the bolts that hold the passenger side fan to shroud
sheet metal patch, i believe it's for pass. side lower front quarter for 73-90 k5.
spread to square bore adapter, although i'm pretty sure it goes both ways, no pun intended, IIRC its a Mr Gasket, p/n 9132
hayden trans cooler, 11" x 11"
induction kit from my 90 K5, needs to be cleaned up
some serpentine stuff, 2 brackets, WP pulley and looks like the crank pulley
auto meter elec. fuel gauge, pn 5174
gas tank skid plate for k5 with 31 gallon tank, the other side is a little rusty, but nothing that couldn't been clean up
set of 8 lug rollers, they hold air, 235/75r16s decent thread on them, but wouldn't run them on the road (one or two of them are plugged)
charcoal canister from when the truck was a 90 TBI
ford super duty tow hooks
mt valve covers, aluminum, need a little refinishing, but are covered in zinc chromate now
set of kc light covers, 6" IIRC
hood hinges from 90 K5
high liner head liner, not sure how it's installed, never got around to putting it in
ford windstar dual fans, i made metal tabs for the mounts as one was cracked, they just need to be drilled out. it's also missing the bolts that hold the passenger side fan to shroud
sheet metal patch, i believe it's for pass. side lower front quarter for 73-90 k5.
spread to square bore adapter, although i'm pretty sure it goes both ways, no pun intended, IIRC its a Mr Gasket, p/n 9132
hayden trans cooler, 11" x 11"
induction kit from my 90 K5, needs to be cleaned up
some serpentine stuff, 2 brackets, WP pulley and looks like the crank pulley
auto meter elec. fuel gauge, pn 5174
