Sliders-DONE, cage-DONE, floor-DONE, dovetail front-DONE, dovetail rear-DONE MUAHA!!

[SCOOBYDANNN]

Makin some progress again on ScoobyDee.

Stuff left to do
Figure a shifter (id like an Art Carr, but $$)
Shorten rear driveshaft
put front window in
wire it up and start it.

and now the pics

cutting out rockers (and friends finger)

Sliders in (2x3x1/4"--i dont think theyre going anywhere)

Front and rear floors cut out (rust) main hoop, a-pillar, and main seat bars.

cage finished, view fron pass side

close up of seat mounts and cage

from the back side

driver side w/ almost flat belly

and my favorite (still might put origional grille, but not sure yet.)

i hope everyone can see it

tell me what you think

 

[85mudblazin]

Nice red X's

 

[SCOOBYDANNN]

i thought it was going too easy.--hold please

 

[mtnman210]

 

[stockk5]

exactly!

 

[SCOOBYDANNN]

fixed

 

[mtnman210]

looking good. What tire and lift combo is on there?

 

[SCOOBYDANNN]

38 sx's on 15x10 rockstomper beadlocks, 6" tuff country front and ORD shackle flip w/ Furd leaves in back---probably going back to 40's or 42's

 

[stockk5]

looks great! u ended up clocking the tcase and such? got pics of that?

 

[SCOOBYDANNN]

t-case is your basic 5 degrees on the 205, but i did move everything up about 2" from stock. i did have to cut out the floor a little

 

[Cricket]

Did you use an adapter to clock the t-case or is it the 6 bolt pattern?

 

[SCOOBYDANNN]

It's a doubler. when you order the adaptor from ORD (and im sure others) you get an option on the clock. so it is the hourglass, not the round.

 

[surpip]

holy crap thats awsome

 

[marv_springer]

Sliders in (2x3x1/4"--i dont think theyre going anywhere)

Go higher.....!!!.

Marv

 

[supersize75k5]

ya that looks like a daily driver rock slider, or a "i still want to run doors" slider

 

[79k20350]

why does this not look right?

Why does the front ad rear angle down so much?it makes it look like alot of stuffs broken from a hard weekend of wheeling.

 

[SCOOBYDANNN]

the front isn't bolted in place in the pic, but the rear dosnt come down as much as it looks.

I dont know why i didnt go higher in the slider, but oh well i kinda like the sound of metal against rocks anyway

 

[jays68yak]

are you doing any kind of bracing on the front sheet metal? Anything to keep the radiator out of the fan?

 

[SCOOBYDANNN]

I didnt really move the rad supprt back any, but yes there will b support for the fenders front and rear.

 

[JIM88K5]

It's the hot new break-over angle set up. Should catch on like the 52in front spring swap