Sloppy spline fit with new np205 flanges

[14-Bolt]

Stock were slightly sloppy, also have new 1410 yoke that fits like a glove. But these new parts mike flanges for the np205 are looser than a 60 year old prostitute. Don.t want them rounding off after all the work I've put into this doubler. You guys have any experience with loose yokes? They are 20 thousands loose if I move it from left to right on spline.

 

[GreenieK30]

Sounds like they were machined to different tolerences then NP parts. Ask Parts Mike if you can swap them for a better one.

 

[cegusman]

How do the splines on the shaft look? Are they wore out at all?

 

[sweetk30]

i dont recall my HAD flanges fitting like that. if i recall thay were nice n snug fit.

 

[14-Bolt]

Parts mike originally f'd my order up and sent me two toyota flanges, then I had to get them to send me the right 32 spline flanges, not dealing with that again. But I am willing to buy some from a vendor that have a snug fit. Seems like the hole they started with before the spline work was to big to start, because the splines are short, causing a loose fit. My output splines are in excelent condition.

 

[sweetk30]

i can go check my 205 with h.a.d flanges. but no pics as camera sucks that close.