What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

SM465 Clutch/Flywheel question

O

Outlaws77

Registered Member
Joined
Jun 15, 2009
Posts
13
Reaction score
0
Location
Show Low, AZ
Ive got the 400sb w/ SM465. I busted my T/O bearing a while back and just got around to pulling everything off to get to it. The bearing came out in 3 pieces, and there were significant wear marks on the pressure plate. What is the best clutch kit for it? I didn't measure the disc that came out, and don't know if I need an 11" or 12". Also, the flywheel looks pretty bad, should I see about getting it resurfaced? or just buy a new one. Ive got about $200 to work with. I appreciate any ideas, thanks.
 
Outlaws77 said:
Ive got the 400sb w/ SM465. I busted my T/O bearing a while back and just got around to pulling everything off to get to it. The bearing came out in 3 pieces, and there were significant wear marks on the pressure plate. What is the best clutch kit for it? I didn't measure the disc that came out, and don't know if I need an 11" or 12". Also, the flywheel looks pretty bad, should I see about getting it resurfaced? or just buy a new one. Ive got about $200 to work with. I appreciate any ideas, thanks.
Click to expand...

I would resurface the flywheel or find a clean used one.
And if you don't know what size you have for the clutch, just ask for a replacement they will know.
I usually go with a stock replacement, I am not racing or anything.:dunno:
 
I'd avoid 12" three finger style pressure plate like the plauge,I had three of them fail after a month or two--get a diaphram style 11 or 12" and your left leg will thank you,the pedal pressure is MUCH less than a three finger style and clamps up just as good as one if not better...
 
I got'r done, however I am having a problem with the shift linkage jackshaft popping off while driving. I am pretty sure I rigged the linkage correctly, could I just mod the shaft to make it longer so it doesnt fall off?
 
If It's falling that means It's loose you need to adjust it.
Outlaws77 said:
I got'r done, however I am having a problem with the shift linkage jackshaft popping off while driving. I am pretty sure I rigged the linkage correctly, could I just mod the shaft to make it longer so it doesnt fall off?
Click to expand...
 
You must log in or register to reply here.

Latest Posts

Top Bottom