Snap ring help

[sandawgk5]

I need to know the size of the size of the snap ring that goes on the stub shaft for a dana 60 that is used to pull the seal tight against the knuckle. It is the one that goes on the stub shaft inside the locking hub.

Thanks

Ira

 

[readymix]

What measurement do you need? I have my D60 apart right now and can take any measurement you need.


BTW. I am transferring to SD in about 6 months or so. We will have too meet up then.

 

[sandawgk5]

I am looking for the inside diameter and possibly thickness of a 30 spline stub snap ring. I need to buy some as I dont have any and I am trying to reassemble today. I know they are not required but they are there for a reason and I feel like I should put them on. For sure when you head this way let me know. I will be transferring to Norfolk in June. I will be going to the Teddy Roosevelt.

 

[readymix]

OK. Give me a few minutes and i will get back to you with the measurements.

 

[readymix]

I know it is a big pic. I kept it like that for ease of reading the text. The direction of the lines indicate where the measurements were taken. If you need any other measurements just ask.
I also put the ID line in the wrong place for the Chevy D60 measurements. The lower line should be ID not OD

 

[sandawgk5]

Thanks for the info I hope I can find them at the parts house.