bigbadchev84
1/2 ton status
This is the stock driveline that was in my 72' when I bought it. It has less than 1000 miles on it. Has a fresh coat of paint and looks new. The previous owner dropped the driveline in my blazer and this was the replacement shaft he had built for it. I ran it for less than 1000 miles.
The upper u-joint had a cap fall off in storage, I have another one on there from a different driveline, but will install a new u-joint for an extra $10 if you are interested.
EDIT: The rear axle in my blazer is a dana 60, I think they are the smaller yoke like a 1/2 ton? Correct me if I am wrong and I will update.
It measures out at 37" collapsed and 39 1/4" extended this is from center of joint to center of joint. Asking $75 shipped
The upper u-joint had a cap fall off in storage, I have another one on there from a different driveline, but will install a new u-joint for an extra $10 if you are interested.
EDIT: The rear axle in my blazer is a dana 60, I think they are the smaller yoke like a 1/2 ton? Correct me if I am wrong and I will update.
It measures out at 37" collapsed and 39 1/4" extended this is from center of joint to center of joint. Asking $75 shipped
Last edited:
