Sold

[K5MONSTERCHEV]

This was in my 72 Blazer. I have a bellhousing to bolt a NV4500 to a Chevy. It has the fork (newer fork and ball not scored like normal) exiting the pasenger side with external slave. I have a pedal out of a mid 90s chevy that has been modified for a first gen. I also have the slave cylinder, master cylinder, line and dust shelid, Centerforce clutch and stock flywheel with about 8K miles on it. I am located in the Bay Area, CA.
Asking $175.

 

[K5MONSTERCHEV]

I also have the stock GM adapter for the transmission to t-case.

 

[bp71k5]

Hi,

Sold! Do you know if I can I run the the passenger side slave on a 4 inch lift with my front drive shaft? Is the GM x-case adaptor included?

I can pick it up tomorrow during the day if you are available.

Brian

 

[bp71k5]

Also, any chance you still have an NV4500?

 

[K5MONSTERCHEV]

I would say yes. I had a 14" lift so it wasn't a problem but honestly I doesn't stick out THAT much. I had a deep oil pan and it wasnt any lower then the oil pan. Heres a pic to kind of give you an idea.

The t case adapter is included. Ill PM you my number.

 

[K5MONSTERCHEV]

Sold, thanks again!

 

[bp71k5]

No problem, it was a good deal. Make sure to let me know if you can access a used/rebuilt/new nv4500 to go with it. Seriously!