Someone shoot a picture for me...

[BoondocK5]

I need a picture of the floor board where the clutch linkage rod goes through the floor.
I just picked up all the linkage real cheap ($19.00) but my cab is an automatic, and I need to get this right.
Thanks in advance.

 

[mdm365]

pics

Here is a few for you.Need and more don't hesitate to ask!

Mike

 

[BoondocK5]

Thanks man!
It looks like the hole needs to be about an inch and 1/2 left of the steering column, and about 4 1/2 inches down from it, right?

The second pic, taken from the outside is the most telling. Almost directly below the speedo cable attach point.

Thanks again!

 

[mdm365]

Thanks man!
It looks like the hole needs to be about an inch and 1/2 left of the steering column, and about 4 1/2 inches down from it, right?

The second pic, taken from the outside is the most telling. Almost directly below the speedo cable attach point.

Thanks again!

I took some measurements from the seam were the floor pan and the firewall meet is 2 1/8 and from the plastic kick panel I get 13 1/4

Mike

 

[original balzer]

Have you checked under the carpet yet?

3 out of the 4 auto to manual conversions I have done had dimples in the floor marking the factory holes.

 

[rompinstompinmudmonkey]

Mine was an auto and I swapped in a 465. The hole was already in the floor in mine and the clutch linkage bolted right up

 

[82355]

Have you checked under the carpet yet?

3 out of the 4 auto to manual conversions I have done had dimples in the floor marking the factory holes.

Yeah, there are generally dimples there.

Martin