is the spindle nut socket for a dana 44 the same for all dana 44's? and is it the same socket for a GM 10 bolt? /forums/images/graemlins/confused.gif
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
spindle lock nut socket
- Thread starter rick88blaze
- Start date
Yep.
thanks Grim, i was asking because Carquest wants $27 for the socket, and Autozone wants $17 for one, but it didn't list the 10 bolt, all it listed were f*rd dana 44's.
rebelk5frk
1/2 ton status
BTW you might want to check advancedauto if there is one close by. The socket they have seems to be a little better than the Autozone one and cost about the same.
I had the autozone socket until a buddy of mine walked off with it. It is fairly thin and is round with just 4 "tips" to fit into the nut. The one I picked up from advanced actually fits over the nut like a normal socket would and has the "tips" inside socket. Hope that made sense. Point is.... The one I have from advanced holds onto the nut a little better than the autozone one did.
I had the autozone socket until a buddy of mine walked off with it. It is fairly thin and is round with just 4 "tips" to fit into the nut. The one I picked up from advanced actually fits over the nut like a normal socket would and has the "tips" inside socket. Hope that made sense. Point is.... The one I have from advanced holds onto the nut a little better than the autozone one did.
aren't Advance and Checker under the same company?
