blazin_blazer
1/2 ton status
from what i understand ..my mech. clutch rod is right in the way of headers....what kind of exhaust do you guys w/non hydro clutch's do w/ your exhaust?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
standard trans..mech. clutch..& headers
- Thread starter blazin_blazer
- Start date
Bogger Man
1/2 ton status
My clutch linkage is fine, I did have to lower the tranny crossmember though. That's what I get for going the cheap way instead of the right way the first time.
Hold my beer & watch this!
Hold my beer & watch this!
I have long tube headers (flowtech) and they are nowhere near the mechanical clutch linkage.
phreddei166
1/2 ton status
I have 465 / 205 , mech. linkage combo and use Hedman Elites. Part no. 69830. Lots of driveshaft and linkage clearance.
Last edited:
blazin_blazer
1/2 ton status
k...good deal...i have a set of hedman long tubes, the jegs catalog says for auto, when i ordered them yrs ago....my friend said he was thinkin they would dump straight into clutch linkage...thanks
I drilled a new hole in my clutch linkage plate on the frame, of course mine is a 1st gen so the plate is higher on the frame.
