Steering assist ram alignment

[pomai]

(1) Could someone help me set up my steering assist ram alignment ? when I turn the steering by hand, the tie rods roll over.

(2) Would this still happen if it was powered by the steering system?

(3) I have the heims threaded all the way in on both sides of the ram, should I thread them half in instead?

All OffRoad Design arms, cross over/ high steer, high steer cylinder mount kit.
Any help will be really appreciated.

Ed

 

[sweetk30]

just a fyi there is 2 washers in the bump stop bracket if your missing some.

 

[Hogback Fabrication]

Can you rotate the tie rod clamp down a little to make the cylinder more parallel with the tie rod? That would help.

We don't carry them, but there are some "wobble stoppers" for tie rod ends out there.

 

[sweetk30]

Can you rotate the tie rod clamp down a little to make the cylinder more parallel with the tie rod? That would help.

We don't carry them, but there are some "wobble stoppers" for tie rod ends out there.

these ? ? ? wobble stoppers

and is it just me or is he missing a jamb nut on the end of the rod were the clamp hiem is ?