stock 350 heads - in decent shape

[Topdown]

just seeing whats available... if someone has a set of stock (complete) heads that they want to part with, lemme know.

-Ryan

 

[R72K5]

i have pair of 76 882 stock passenger car heads but youre in WA,.

hmm,.,

thanks

 

[crazy427]

i have a set of 89 tbi heads clean good shape and complete w/ valvecovers. let me know

 

[big83chevy4x4]

i got some rebuilt heads that i want to sell, they are the 441 casting. brand new springs, seals, valve job. they are even painted orange. i want $165 for them.

 

[Topdown]

whats the diff between a TBI head and a non-TBI head?

 

[kennyw]

[ QUOTE ]
whats the diff between a TBI head and a non-TBI head?

[/ QUOTE ]

Which intake fits without too much modification. The aftermarket intake for TBI heads runs about $50-75 more than the equal non tbi.

 

[Topdown]

ah... thanks /forums/images/graemlins/smile.gif

 

[4xrick]

i got a set of heads sitting in the garage im not sure exzactly what the deal is with them they came off my old 350 not sure about the casting but i will look tomorrow i think i would sell for 50$ or so.

 

[crazy427]

you can use any sbc intake on the tbi heads you just have to elongate the 4 center bolt holes. On thetbi heads the go in strait down, where as the older heads go in at an angle.Ill take 40 bucks for them plus shipping and ill include the heads bolts. /forums/images/graemlins/deal.gif

 

[R72K5]

what crazy said to do with the center four intake holes will work fine, just is different angle on those four bolts only, no biggie

i would trade someone my 882's for a set of later model 305 350 heads 87-up only cuz i just want center bolt covers setup on my 76 engine, but i dont know when i would be able to afford mail on two heads, not for a little while at very minimum, and most likely longer than that for sure, hmm...

thanks

good luck

 

[Topdown]

yeah, I couldnt afford shipping on cast iron heads right now...

 

[Topdown]

cool... let me know what casting they are and what condition they are in and I can probably manage to get them transportation from Redmond to Vancouver... /forums/images/graemlins/thumb.gif

 

[4xrick]

ok I am not meaning to sound stupid here but i cant remember how to check what casting they are one set is off a 77 block and one off and early 80's block i will check them tomorrow and see what i can figure out.pm me your # and we can do something i actually have a way to get them down there tomorrow I know its short notice but let me know.
Rick

 

[Topdown]

there should be a number stamped into the head, inside the rocker valley... (if I remember right)

yeah I am interested still... /forums/images/graemlins/thumb.gif

my number is 360 772 0265

 

[4xrick]

ok the # on the heads is 3417369 I have no clue what that tells you but let me know if you want them.

 

[R72K5]

33417369...90-up...350..........Gen.I Goodwrench crate motor,
"Hecho en Mexico", 76cc


gen 1 clockwise cooling*

 

[Topdown]

you bet... I can bolt those bad-boyz on and have that motor running again in no-time.

 

[4xrick]

ok so I am a little confused now do you want the heads i got? I left you a message on the # you gave me but never got a call back sp pm me if you wnat them of give me a call back.
Rick