I want to mount my switches (lights, in-cab winch controls, etc) in a clean and functional place. What has everyone here done with their switches? Show me some pics please.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
switch mounting
- Thread starter AKbigsub
- Start date
No pics, but I have a "shelf" and built a switch panel that mounts on it. It hides the wires and the switches are all up high on the edge of the drivers side.
TruckNutzDude
1/2 ton status
I made a panel that replaces my stereo since I no longer have a stereo it was the best place
Muddytazz
1 ton status
The In-cab winch controls I had mounted in the vent and the other switched I turned that panel into a raised panel so the switches mounted flat.
VikingWarlord
1/2 ton status
I used my ashtray. Flips down and covers KC light switches and my alarm valet switch. I can take a pic if you would like, its really basic and still has the lighter available.
VikingWarlord said:
Since I don't smoke, I often use the ashtray for switches on my trucks:
On my topless, doorless rig I opted for no radio and so the switches now go there:
Or there are the various AC vents which may be disused
-- A
lower left... where ac vent goes... mounted the switches to the dash...
upper right where the ac vent is...
these mounted right to the gauge cover.. wish I could have put them on the metal dash but you cant...
upper right where the ac vent is...
these mounted right to the gauge cover.. wish I could have put them on the metal dash but you cant...
I really like the ash tray location. The switches are all protected and accessable at the same time. Thanks for the input!
Does anyone else have any pics of what's been done?
