Taking out a body lift

[SUPER'BURB]

When I aquired my rig it had a 2" body lift in it.
If I get twisted up my fan hits the shroud .

Sooo......

Whats involved in removing it.
Would the tranny and t-case have been shimmed up/down?
What would need to be done with the linkages and drive shafts?

I wish this was not on my rig .

 

[retroblazer]

Why not put an electric fan in and leave the lift kit alone?

 

[sweetk30]

just trim the shroud. when you need to remove drive line stuff later you will wish you had it in. much easyer.

 

[SUPER'BURB]

Why not put an electric fan in?

I was planning on doing that any way.

My concern is with the extra twist. Will it cause any issues?

Thanks for the help guys.

 

[TrcksR4ME]

Just take it out, body lifts more than 1"...well suck

It will not affect your drivelines, t-case, tranny....remember body lift is just as it sounds, it lifts the body off the frame. Where you run into issues is with tranny linkage if you have an auto-you just need to adjust it after removing the BL.