lookin for shift linkage for my th400. the truck had a 3" body lift so the linkage was cut and a section was welded in. if anybody has the stock linkage that would be awesome. the truck is a '85 k30.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
th400 shift linkage
- Thread starter muddybuddy
- Start date
I picked up a TH400 recently with the shift linkage still attached. I'll sell you everything from the column down to the tranny for $25 shipped.
Jimbo*
1/2 ton status
Just cut 3" off the end of yours.
Jimbo
Jimbo
all shift linkage is the same. the sector shaft in all 3 trannys stayed in the same place. only diffrence is the rod clip that bolts to the secter shaft on the tranny for some models over the years.
old truck i had was 700r4 and i swaped in a th350 no problems. then other truck was 700r4 and swaped in 4l80-e no problems.
old truck i had was 700r4 and i swaped in a th350 no problems. then other truck was 700r4 and swaped in 4l80-e no problems.
Jimbo* said:
if i had a welder thats exactly what id do. until then i cant cut and weld
Jimbo*
1/2 ton status
??Hacksaw???
He would still be left with 2 pieces he can't weld back together.Jimbo* said:
Jimbo*
1/2 ton status
I was referring to cutting 3" off the end of the rod.
Jimbo* said:
My thoughts exactly.
It should be an open end rod that slides in to adjust the height.
He can even leave that in except it will be hanging too low.
